RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Fuel Gauge Sender: Service and Repair
REMOVAL
The fuel level sending unit (fuel level sensor) and float assembly (7) is located on the side of the fuel pump module.
1. Remove fuel pump module from fuel tank. Refer to Fuel Pump Module Removal/Installation.
2. Disconnect 4-wire electrical connector (3) from fuel pump module. Separate necessary sending unit wiring from connector using terminal pick /
removal tool. Refer to Special Tools in Wiring for tool part numbers.
3. To remove sending unit from pump module, lift on plastic locking tab while sliding sending unit tracks.
INSTALLATION
1. Connect necessary wiring into electrical connectors. Connect 4-wire electrical connector to pump module.
2. Position sending unit to pump module. Slide and snap into place.
3. Install fuel pump module. Refer to Fuel Pump Module Removal/ Installation.