RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
1. (G10) SEAT BELT SWITCH SENSE CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the Seat Belt Switch harness connector.
Disconnect the Instrument Cluster C3 harness connector.
Measure the resistance between ground and the (G10) Seat Belt Switch Sense circuit.
Q: Is the resistance below 5.0 ohms?
YES: Repair the (G10) Seat Belt Switch Sense circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Replace and configure the Instrument Cluster. Perform BODY VERIFICATION TEST - VER 1. See: Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
Seat Belt Warning Indicator Always on
SEAT BELT WARNING INDICATOR ALWAYS ON