RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Pilot Bearing: Service and Repair
BEARING PILOT
REMOVAL
1. Remove transmission assembly from the vehicle.
2. Remove pressure plate (2) and clutch disc.
3. Remove pilot bearing with an internal puller and slide hammer to remove.
INSTALLATION
1. Clean bearing bore with solvent and wipe dry with shop towel.
2. Install new bearing (1) with clutch alignment tool (2) and letter side of the bearing (3) facing the transmission. Bearing should be flush with edge
of bearing bore.
CAUTION: Do not allow bearing to become cocked and do not recess bearing.
3. Install clutch disc, pressure plate and transmission.