RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Seals and Gaskets: Service and Repair
NV244 GenII
Seal-Extension Housing
SEAL-EXTENSION HOUSING
REMOVAL
1. Raise and support vehicle.
2. Remove rear propeller shaft.
3. Using a suitable pry tool or slide-hammer mounted screw, remove the extension housing seal.
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Using Installer D-163 (2) and Handle C-4171 (1), install seal in extension housing.
3. Install propeller shaft.
4. Verify proper transfer case fluid level.
5. Lower vehicle.
Seal-Front Output Shaft Removal
SEAL-FRONT OUTPUT SHAFT REMOVAL
1. Remove the front propeller shaft.
2. Remove the front propeller shaft seal boot retaining clamp (2)
