RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Garage Door Opener Transmitter: Service and Repair
STANDARD PROCEDURE - ERASING TRANSMITTER CODES
To erase the universal transmitter codes, simply hold down the two outside buttons until the display confirms operation.
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
STANDARD PROCEDURE - SETTING TRANSMITTER CODES
1. Turn OFF the engine.
2. Erase the factory test codes by pressing the two outside buttons. Release the buttons when the display confirms operation (about 20 seconds).
3. Choose one of the three buttons to train. Place the hand-held transmitter within one inch of the universal transmitter and push the buttons on both
transmitters.
4. Release both buttons. Your universal transmitter is now "trained". To train the other buttons, repeat Step 3 and Step 4. Be sure to keep your
handheld transmitter in case you need to retrain the universal transmitter.
