RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Rear Door Panel: Service and Repair
Rear Door Trim Panel
REMOVAL
Fig. 20 Window Crank Removal Tool
1. Remove the window crank, if equipped.
2. Remove the interior handle.
Fig. 9 Trim Panel
3. Remove the screw near the inside handle.
CAUTION: Trim panel is attached to the door using hooks molded into the panel. Do not pull the trim panel straight off or damage to the panel
and/or power switch assembly may occur.
4. Lift the trim panel up off the belt seal and attachment hooks and separate the panel from the door slightly
5. Disconnect the power window switch electrical connector, if equipped, and remove the trim panel.
INSTALLATION
1. Position the trim panel onto the lower hooks and connect the power window switch electrical connector, if equipped.
2. Position the remaining trim panel attachment hooks into the door panel and seat the trim panel into the belt seal fully.
3. Install the screw near the inside handle.
4. Install the interior handle.
