RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Body Emblem: Service and Repair
EXTERIOR NAME PLATES
NOTE: Mega Cab model shown in the illustration. Exterior name plates and decals for all other cab models are similar. Exterior name plate and decal
usage vary by model.
REMOVAL
Name Plates
1. As a guide for installation, apply a length of masking tape on the body (1), parallel to the top edge and, to one end of the name plate or decal (2)
being removed.
CAUTION: Do not exceed 52 degrees C (120 degrees F) when heating name plates, decals or body panels. Failure to follow this caution
may result in damage to the name plates, decals and/or the vehicle paint finish.
2. If the temperature is below 21 degrees C (70 degrees F), warm the name plate or decal with a heat lamp or heat gun.
NOTE: The exterior name plates are attached to the body with adhesive tape.
3. Using a trim stick C-4755 or equivalent, carefully remove the name plate or decal from the body panel, as necessary.
INSTALLATION
