RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
2. Lockout the parking brake cable.
3. Loosen the brake adjuster nut.
4. Remove the left brake cable from the equalizer.
5. Remove the brake cable from the frame bracket.
6. Remove the brake cable from the brake lever.
Rear Park Brake Cable
INSTALLATION - REAR PARK BRAKE CABLE
1. Push each cable end through the brake cable support plate hole until the cable end fitting tabs lock into place.
NOTE: Pull on the cable to ensure it is locked into place.
2. Push the cable through the frame bracket.
3. Lock the left cable end fitting tabs into the frame bracket hole.
4. Install the rear cables into the tensioner rod behind the rear of the brake assembly.
5. Install the cable to the intermediate cable connector.
6. Release and remove the lock out device.
7. Perform the park brake adjustment procedure.
8. Remove the supports and lower the vehicle.
Right Rear Cable
INSTALLATION - RIGHT REAR CABLE
