RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Parking Brake Tensioner: Adjustments
CABLE TENSIONER ADJUSTMENTS
ADJUSTMENT
NOTE: Tensioner adjustment is only necessary when the tensioner, or a cable has been replaced or disconnected for service. When adjustment is
necessary, perform adjustment only as described in the following procedure. This is necessary to avoid faulty park brake operation.
1. Raise the vehicle.
2. Back off the cable tensioner adjusting nut to create slack in the cables.
3. Remove the rear wheel/tire assemblies. Then remove the brake rotors.
4. Verify the brakes are in good condition and operating properly.
5. Verify the park brake cables operate freely and are not binding, or seized.
6. Check the rear brake shoe adjustment with standard brake gauge.
7. Install the rotors and verify that the rotors rotate freely without drag.
8. Install the wheel/tire assemblies.
9. Lower the vehicle enough for access to the park brake foot pedal. Then fully apply the park brakes.
NOTE: Leave park brakes applied until adjustment is complete.
10. Raise the vehicle again.
11. Mark the tensioner rod 6.35 mm (1/4 inch) from edge of the tensioner.
12. Tighten the adjusting nut on the tensioner rod until the mark is no longer visible.
CAUTION: Do not loosen, or tighten the tensioner adjusting nut for any reason after completing adjustment.
13. Lower the vehicle until the rear wheels are 15 - 20 cm (6 - 8 inch) off the shop floor.
14. Release the park brake foot pedal and verify that rear wheels rotate freely without drag. Then lower the vehicle.
