RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Vacuum Brake Booster: Service and Repair
POWER BRAKE BOOSTER
REMOVAL
1. Remove master cylinder.
2. Disconnect vacuum line at booster.
3. Remove clip securing booster push rod to brake pedal.
4. Remove the nuts from the booster mounting studs.
5. Remove the booster and gasket from front cowl panel.
INSTALLATION
1. Guide the booster studs into the cowl panel holes and seat the booster on the panel.
2. Install and tighten new booster attaching nuts to 28 Nm (250 inch lbs.).
3. Install the booster push rod on brake pedal and install clip.
4. Install the booster check valve if removed and connect the vacuum hose to the check valve.
5. Install the master cylinder.
6. Fill and bleed the brake system.
