RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
2. Install Camshaft Holder Tool C-3509 with tongue back of distributor drive gear (Fig. 23).
3. Hold tool in position with a distributor lockplate bolt. This tool will restrict camshaft from being pushed in too far and prevent knocking out the
welch plug in rear of cylinder block. Tool should remain installed until the camshaft and crankshaft sprockets and timing chain have been installed.
4. Install camshaft thrust plate and chain oil tab. Make sure tang enters lower right hole in thrust plate. Tighten bolts to 24 Nm (210 inch lbs.) torque.
Top edge of tab should be flat against thrust plate in order to catch oil for chain lubrication.
5. Install timing chain and gears.
6. Measure camshaft end play. If not within limits install a new thrust plate.
7. Each tappet reused must be installed in the same position from which it was removed. When camshaft is replaced, all of the tappets must be
replaced.
8. Install distributor and distributor drive shaft.
9. Install push rods and tappets.
10. Install rocker arms.
11. Install timing case cover.
12. Install cylinder head covers.
13. Install intake manifold.
14. Install the engine cover.
15. Install the A/C Condenser (if equipped)
16. Install the radiator.
17. Start engine check for leaks.
