RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
1. If removed, position new plenum gasket and install plenum pan (Fig. 70).
2. Tighten plenum pan mounting bolts as follows:
-
Step 1. Tighten bolts to 5.4 Nm (48 inch lbs.)
-
Step 2. Tighten bolts to 9.5 Nm (84 inch lbs.)
-
Step 3. Check all bolts are at 9.5 Nm (84 inch lbs.)
3. Install the flange gaskets. Ensure that the vertical port alignment tab is resting on the deck face of the block. Also the horizontal alignment tabs
must be in position with the mating cylinder head gasket tabs (Fig. 72). The words MANIFOLD SIDE should be visible on the center of each
flange gasket.
4. Apply Mopar GEN II Silicone Rubber Adhesive Sealant, or equivalent, to the four corner joints. An excessive amount of sealant is not required to
ensure a leak proof seal. However, an excessive amount of sealant may reduce the effectiveness of the flange gasket. The sealant should be
