RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Front Crankshaft Seal: Service and Repair
CRANKSHAFT OIL SEAL - FRONT
REMOVAL
The oil seal can be replaced without removing the timing chain cover, provided that the cover is not misaligned.
1. Disconnect the negative cable from the battery.
2. Remove vibration damper.
3. If front seal is suspected of leaking, check front oil seal alignment to crankshaft. The seal installation/alignment Tool 6635, should fit with
minimum interference. If tool does not fit, the cover must be removed and installed properly.
4. Place a suitable tool behind the lips of the oil seal to pry the oil seal outward. Be careful not to damage the crankshaft seal bore of cover.
INSTALLATION
1. Place the smaller diameter of the oil seal over Front Oil Seal Installation Tool 6635 (Fig. 30). Seat the oil seal in the groove of the tool.
2. Position the seal and tool onto the crankshaft (Fig. 31).
