RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
47.
Insert the applicator tool into the blower resistor opening. Spray the full contents of the bottle onto the evaporator while moving the applicator tool
up and down and back and forth so that the evaporator is evenly coated.
48.
Allow the vehicle to sit for 30 minutes.
49.
Install the blower motor resistor/power module.
50.
On LX/RS/**2005 WH/WK vehicles, raise the vehicle on a suitable hoist. On 2006 - 2007 WH/WK/XH/XK skip to step 53. Other vehicles
proceed to next step.**
CAUTION:
The excess cooling coil coating will drain when the cap/clamp/plug is removed in the next step.
51.
Remove the drain tube cap/clamp.
52.
On LX/RS/**2005 WH/WK** vehicles (other vehicles proceed to next step), lower the vehicle.
53.
Start the engine.
54.
Raise all the windows to a slightly open position (about 1/2 inch opening).
55.
Set the blower to HIGH.
56.
Set the A/C switch to A/C OFF.
57.
Set mode switch to PANEL OUTLETS.
58.
Set temperature switch to FULL HEAT.
59.
Set recirculation switch to RECIRCULATE.
60.
Allow the engine to run for 20 minutes.
61.
Turn the ignition switch to the OFF position.
62.
Fill an 8 ounce plastic bottle with warm water and screw onto applicator tool. Clean tool by spraying warm water under pressure into the shop
sink. Wipe the tool and store for next use.
63.
On LX/RS/**2005 WH/WK vehicles, raise the vehicle on a suitable hoist. On 2006 - 2007 WH/WK/XH/XK skip to step 67. Other vehicles
proceed to next step.**
CAUTION:
In the following step be careful not to damage the A/C cooling coil.
64.
Using a suitable object (a wire coat hanger for example), probe the drain tube 3.8 - 5.1 cm (1.5 - 2 in.) to ensure that the dried coil coating is not
restricting the flow from the drain tube.
65.
AB vehicles proceed to Step # 72, CS vehicles proceed to Step # 68, LX/RS/**2005 WH/WK** vehicles proceed to Step # 66.
66.
Lower the vehicle.
67.
On **LX/WH/WK/XH/XK** vehicles (RS vehicles proceed to next step), install the right silencer pad.
68.
Install the glove box.
69.
If the vehicle is not equipped with an A/C air filter, proceed to the next step. If equipped with an A/C filter, remove the air filter door and install
the A/C air filter. Replace with a new filter, if necessary. See the parts table for the appropriate part number filter.
70.
Remove the carpet and seat protector.
71.
Install the floor mat.
72.
Close the hood.
AN/DN/DR/HB/JR/KJ/LH/ND/PL/PT/TJ/WG/WJ Vehicles Procedure
