RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
5. Remove the heater core tube bracket.
6. Pull the heater core out of the HVAC housing.
7. Inspect all foam seals and repair or replace them as required.
INSTALLATION
1. Install the heater core into the HVAC housing.
2. Position the heater core tube bracket onto the HVAC housing.
3. Install the two screws that secure the heater core bracket to the HVAC housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
4. If equipped with the Dual Zone system, install the linkage rod onto the actuator levers.
5. Install the foam seal onto the heater core tubes.
6. Install the HVAC housing. Refer to Housing Assembly HVAC/ Service and Repair/ Procedures. See: Housing Assembly HVAC/Service and
Repair
