dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Map Light|Service and Repair > < Map Light|Diagrams
Page 1
background image

Map Light: Description and Operation

The overhead console in this vehicle is equipped with two individual reading and courtesy lamps. The lamp lenses are the only visible components of
these lamps. Each lamp has its own switch, bulb, reflector and lens within the overhead console.

The overhead console reading and courtesy lamps are controlled by the instrument cluster which provides power at all times, regardless of the ignition
switch position. The ground circuit for the lamps is switched through the integral reading and courtesy lamp switches or through the door ajar switches.
Each lamp is designed and aimed to provide illumination that will be directed only to that side of the vehicle on which the lamp is located.

The reading and courtesy lamp lenses and bulbs are available for service replacement. The reading and courtesy lamp switches, bulb holders and wiring
are only available as part of the overhead console wire harness. If either of the lamp switches or bulb holders is faulty or damaged, the entire overhead
console wire harness assembly must be replaced.

For service of the reading and courtesy lamp bulbs, refer to the appropriate wiring information.

All reading and courtesy lamps located in the overhead console are activated by the door ajar switches via the instrument cluster. When all of the doors
are closed, these lamps can be individually activated by depressing the corresponding lens. When any door is open, depressing the lamp lenses to
activate the lamp switches will not turn the lamps OFF.

The instrument cluster monitors the door ajar switches. When a door is open the instrument cluster grounds the low side drivers to turn on the lamps.
Upon closing all doors, the instrument cluster initiates a 30 second timer. If any of the doors are opened during the "time out" cycle, the instrument
cluster will reset the timer until all doors are closed. The instrument cluster will faid to OFF when the doors are closed and the ignition is turned ON, the
time out expires or the power locks are activated.

Map Light|Service and Repair > < Map Light|Diagrams