RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Brake Fluid: Service and Repair
The fluid of the master cylinder should be checked when performing under the hood service, or immediately if the brake system warning lamp
indicates system failure.
The brake master cylinder has a translucent plastic reservoir. On the outboard side of the reservoir, there is a "MAX" dot and an "MIN" dot. The fluid
level must be kept within these two dots. Do not add fluid above the full mark, because leakage may occur at the cap.
With disc brakes the fluid level can be expected to fall as the brake linings wear. However, an unexpected drop in fluid level may be caused by a leak
and a system check should be conducted.
Only brake fluid conforming to MVSS DOT 3 and SAE J1703 should be used. Mopar brake fluid is of this quality and is recommended to provide
best brake performance.
WARNING!
Use of a brake fluid that may have a lower initial boiling point, or is unidentified as to specification, may result in sudden brake failure
during hard prolonged braking. You could have an accident.
Use only brake fluid that has been in a tightly closed container to avoid contamination from foreign matter or moisture.
CAUTION!
Do not allow a petroleum-base fluid to contaminate the brake fluid. Seal damage may result.
