RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL
Fig. 27 MAP Sensor - 5.9L
Fig. 28 MAP Sensor L-Shaped Rubber Fitting - 5.9L
The MAP sensor is located on the front of the throttle body. An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.
1. Clean area around MAP sensor.
2. Remove two MAP sensor mounting bolts (screws).
3. While removing MAP sensor, slide the vacuum rubber L-shaped fitting from the throttle body
4. Remove rubber L-shaped fitting from MAP sensor.
INSTALLATION
The MAP sensor is located on the front of the throttle body. An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.
1. Install rubber L-shaped fitting to MAP sensor.
2. Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.