RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Remove throttle body from intake manifold.
7. Discard old throttle body-to-intake manifold gasket.
INSTALLATION
A (factory adjusted) set screw is used to mechanically limit the position of the throttle body throttle plate. Never attempt to adjust the engine idle
speed using this screw. All idle speed functions are controlled by the powertrain control module (PCM).
1. Clean the mating surfaces of the throttle body and the intake manifold.
2. Install new throttle body-to-intake manifold gasket.
3. Install throttle body to intake manifold.
4. Install four mounting bolts. Tighten bolts to 23 Nm (200 in. lbs.) torque.
5. Install control cables.
6. Install vacuum line to throttle body.
7. Install electrical connectors.
8. Install air resonator tube.
