RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Body Control Module: Reading and Clearing Diagnostic Trouble Codes
Displaying and Reading Trouble Codes
USING THE DRB III
Refer to the DRB III user's guide for instructions and assistance with reading trouble codes, erasing trouble codes, and other DRB III functions.
DRB III ERROR MESSAGES AND BLANK SCREEN
Under normal operation, the DRB III will display one of only two error messages:
User-Requested WARM Boot or User Requested COLD Boot.
If the DRB III( R) should display any other error message, record the entire display and call the STAR Center. This is a sample of such an error message
display.
User-Requested WARM Boot by pressing MORE and NO at the same time.
ver:
2.29
date:
1 Oct 93
file:
key_itf.cc
date:
Jan 12 1994
line:
544
err:
Ox1
User-Requested WARM Boot
Press MORE to switch between this display and the application screen.
Press F4 when done noting information.
- OR
User-Requested COLD Boot by pressing MORE and YES at the same time.
ver:
2.29
date:
1 Oct 99
file:
keyhnd1.cc
date:
Mar 8 2000
line:
1297
err:
Ox1
User-Requested COLD Boot
Press MORE to switch between this display and the application screen.
Press F4 when done noting information.
DRB III Does Not Power Up
If the LEDs do not light or no sound is emitted at start up, check for loose cable connections or a bad cable. Check the vehicle battery voltage (data link
connector cavity 16). A minimum of 11 volts is required to adequately power the DRB III. Check for proper ground connection at DLC cavities 4 and 5.
If all connections are proper between the DRB III and the vehicle or other devices, and the vehicle battery is fully charged, and inoperative DRB III may
be the result of faulty cable or vehicle wiring.