RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Fluid Pressure Sensor/Switch: Service and Repair
45RFE - Automatic Transmission
Line Pressure (LP) Sensor / REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the line pressure sensor (Fig. 92).
4. Remove the bolt holding the line pressure sensor to the transmission case.
5. Remove the line pressure sensor from the transmission case.
INSTALLATION
1. Install the line pressure sensor into the transmission case.
2. Install the bolt to hold the line pressure sensor into the transmission case. Tighten the bolt to 11.9 Nm (105 inch lbs.).
3. Install the wiring connector onto the line pressure sensor
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
