RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Remove the negative battery cable from the battery.
2. Pull up on the CAB harness connector release and remove connector.
3. Remove the CAB mounting bolts.
4. Remove the pump connector from the CAB.
5. Remove the CAB from the HCU.
INSTALLATION
1. Install CAB to the HCU.
2. Install the pump connector to the CAB.
3. Install mounting bolts. Tighten to 2 Nm (16 in. lbs.).
4. Install the wiring harness connector to the CAB and push down on the release to secure the connector.
5. Install negative battery cable to the battery.