RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Gear Sensor/Switch: Service and Repair
NV241/GEN II - Transfer Case
REMOVAL
1. Raise and support the vehicle.
2. Disengage the transfer case position sensor connector from the position sensor.
3. Remove the position sensor from the transfer case.
INSTALLATION
1. Inspect the O-ring seal on the transfer case position sensor. Replace the O-ring if necessary.
2. Install the transfer case position sensor into the transfer case. Torque the sensor to 20 - 34 Nm (15 - 25 ft. lbs.).
3. Engage the transfer case position sensor connector to the position sensor.
4. Lower vehicle.
5. Verify proper sensor operation.
