RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Micro ISO Relay: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the relay by grasping it firmly and pulling it straight out from its receptacle. A slight back and fourth rocking motion may help the
removal process.
INSTALLATION
1. Align the micro-relay terminals with the terminal cavities in the receptacle.
2. Push firmly and evenly on the top of the relay until the terminals are fully seated in the terminal cavities in the receptacle.
3. Connect the battery negative cable.
