RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Tie Rod End: Service and Repair
REMOVAL - OUTER TIE ROD END
NOTE: Do not twist the boot anytime during removal or installation.
1. Loosen the jam nut.
2. Remove the outer tie rod end nut from the ball stud.
3. Separate the tie rod ball stud from the knuckle with Remover 8677.
4. Unthread the outer tie rod end from the inner tie rod.
INSTALLATION - OUTER TIE ROD END
NOTE: Do not twist the boot at anytime during removal or installation.
1. Thread the outer tie rod end onto the inner tie rod, to it's original position.
2. Install the outer tie rod end into the steering knuckle.
3. Tighten the ball stud nut on the ball stud to 75 Nm (55 ft. lbs.).
4. Set wheel toe pattern.
5. Tighten jam nut to 75 Nm (55 ft. lbs.).