RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Torsion Bar: Service and Repair
Torsion Bar
REMOVAL
CAUTION: The left and right side torsion bars are NOT interchangeable. The bars are identified and stamped R or L, for right or left. The bars do not
have a front or rear end and can be installed with either end facing forward.
1. Raise and support the vehicle with the front suspension hanging.
2. Remove the transfer case skid plate.
NOTE: Count and record the number of turns for installation reference.
3. Mark the adjustment bolt setting.
4. Install Special Tool - 8686 to the anchor arm and the crossmember.
5. Increase the tension on the anchor arm tool until the load is removed from the adjustment bolt and the adjuster nut.
6. Turn the adjustment bolt counterclockwise to remove the bolt and the adjuster nut.
7. Remove the Special Tool - 8686, allowing the torsion bar to unload.
8. Remove torsion bar and anchor. Remove anchor from torsion bar.
9. Remove all foreign material from torsion bar mounting in anchor and suspension arm.
10. Inspect adjustment bolt, bearing and swivel for damage.
INSTALLATION