RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
INSPECTION
Inspect the servo components (Fig. 112). Replace the springs if collapsed, distorted or broken. Replace the guide, rod and piston if cracked, bent, or
worn. Discard the servo snap-ring if distorted or warped.
Check the servo piston bore for wear. If the bore is severely scored, or damaged, it will be necessary to replace the case.
Replace any servo component if doubt exists about condition. Do not reuse suspect parts.
46RE - Automatic Transmission
FRONT SERVO - ASSEMBLY
Clean and inspect front servo components.
1. Lubricate new O-ring and seal rings with petroleum jelly and install them on piston, guide and rod.