RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Install new pump seal with Installer Tool C-3860-A (Fig. 131). Use hammer or mallet to tap seal into place.
7. Install new O-ring on pump body. Lubricate oil seal and O-ring with petroleum jelly.
8. Cover pump assembly to prevent dust entry and set aside for assembly installation.
OUTPUT SHAFT FRONT BEARING
REMOVAL
1. Remove overdrive unit from the vehicle.
2. Remove overdrive geartrain from housing.
3. Remove snap-ring holding output shaft front bearing to overdrive geartrain. (Fig. 132).
4. Pull bearing from output shaft.
INSTALLATION
1. Place replacement bearing in position on geartrain with locating retainer groove toward the rear.
2. Push bearing onto shaft until the snap-ring groove is visible.
3. Install snap-ring to hold bearing onto output shaft.
4. Install overdrive geartrain into housing.
5. Install overdrive unit in vehicle.