RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
7. Verify that throttle lever is aligned with end of kickdown valve stem and that manual lever arm is engaged in manual valve (Fig. 342).
8. Position line pressure adjusting screw in adjusting screw bracket.
9. Install spring on end of line pressure regulator valve.
10. Install switch valve spring on tang at end of adjusting screw bracket.
11. Install manual valve.
12. Install throttle valve and spring.
13. Install kickdown valve and detent.
14. Install pressure regulator valve.
15. Install switch valve.
16. Position adjusting screw bracket on valve body. Align valve springs and press bracket into place. Install short, upper bracket screws first and long
bottom screw last. Verify that valve springs and bracket are properly aligned. Then tighten all three bracket screws to 4 Nm (35 inch lbs.) torque.
17. Perform Line Pressure and Throttle Pressure adjustments.
18. Lubricate solenoid case connector O-rings and shaft of manual lever with light coat of petroleum jelly.
19. Attach solenoid case connector to 3-4 accumulator with shoulder-type screw. Connector has small locating tang that fits in dimple at top of
accumulator housing (Fig. 343). Seat tang in dimple before tightening connector screw.
20. Install solenoid assembly and gasket. Tighten solenoid attaching screws to 8 Nm (72 inch lbs.) torque.
