RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
21. Remove pinion depth shim (Fig. 53) from the pinion shaft and record shim thickness.
INSTALLATION
NOTE: The ring gear and pinion are serviced in a matched set. Do not replace one gear without replacing the other matching gear. If ring and pinion
gears or bearings are replaced, refer to Adjustments for Pinion Gear Depth Setting.
1. Apply Mopar Door Ease or equivalent stick lubricant to outside surface of the pinion bearing cups.
2. Install rear pinion bearing cup (Fig. 54) with Installer C-4308 and Driver Handle C-4171 and verify cup is seated.