RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Record pinion rotating torque using an inch pound torque wrench. The rotating torque should be equal to the reading recorded during removal plus
an additional 0.56 Nm (5 inch lbs.) (Fig. 31).
7. If rotating torque is low, tighten the pinion nut in 6.8 Nm (5 ft. lbs.) increments until the proper rotating torque is achieved.
CAUTION: If maximum tightening torque 475 Nm (350 ft. lbs.) is reached prior to reaching the required rotating torque, the collapsible spacer may
have been damaged. Replace the collapsible spacer.
8. Install propeller shaft with reference marks aligned.
9. Add gear lubricant to differential housing if necessary.
10. Install half shafts.
