RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Remove dust boot clamp (Fig. 10) from the C/V joint end of the shaft.
7. Remove propeller shaft.
INSTALLATION
1. Install propeller shaft with all reference marks aligned.
2. Install transfer case companion flange bolts and tighten to 30.5 Nm (22.5 ft. lbs.).
3. Install axle companion flange bolts and tighten to 108 Nm (80 ft. lbs.).
4. Install skid plate, if equipped.
5. Lower vehicle and road test to verify repair.
Standard Procedure - Propeller Shaft Angle
Standard Procedure - Propeller Shaft Angle
This procedure applies to both the front/rear propeller shafts. To obtain the front output angle (A) on the front propeller shaft, place the inclinometer the
machined surface of the CV joint.
PROPELLER SHAFT ANGLE
1. To check driveline alignment, raise and support the vehicle at the axles as level as possible. Allow the wheels and propeller shaft to turn.
2. Remove any external bearing snap rings, if equipped from universal joint so protractor base sits flat.
3. Rotate the shaft until transmission/transfer case output yoke bearing is facing downward.
NOTE: Always make measurements from front to rear and from the same side of the vehicle.
