RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
6. Rotate propeller shaft 90 degrees and place Inclinometer on companion flange yoke bearing parallel to the shaft (Fig. 6). Center bubble in sight
glass and record measurement.
This measurement will give you the pinion Companion Flange Input Angle (B).
7. Subtract smaller figure from larger (C minus A) to obtain Transmission/Transfer Case Output Operating Angle.
8. Subtract smaller figure from larger (C minus B) to obtain axle Input Operating Angle.
Refer to rules given below and the example in (Fig. 7) for additional information.
-
Good cancellation of U joint operating angles should be within 1°.
-
Operating angles should be less than 3°.
-
At least 1/2 of one degree continuous operating (propeller shaft) angle.