RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Window Regulator - Power
8. Remove the forward regulator bolt and loosen the other two.
9. Slide the regulator up and out of the keyhole slots in the door panel.
10. Disconnect the electrical connector and remove the regulator.
INSTALLATION
1. Install the regulator through the door panel opening and connect the electrical connector.
2. Position the regulator bolts into the keyhole slots and slide into place.
3. Install the forward bolt and tighten all three to 10 N.m (89 in. lbs.).
4. Position the stabilizer, install the nuts and tighten to 10 N.m (89 in. lbs.).
5. Raise the regulator to the position shown in figure.
6. Remove the glass support and connect to the regulator lift plate.
7. Install the glass nuts and tighten to 10 N.m (89 in. lbs.).
8. Disconnect the window switch and install into the door trim panel.
9. Install the waterdam.
