RAM 1500 Van V6-3.9L VIN X (1997)
Parking Brake Pedal: Service and Repair
REMOVAL
1. Raise and support vehicle.
2. Disconnect cable spring.
3. Remove adjusting nut from front cable.
4. Lower vehicle.
Parking Brake Pedal
5. Compress and disengage cable retainer from pedal bracket.
6. Loosen hex screw on cable retaining clamp.
7. Push ball end of cable out of pedal assembly with small screwdriver and slide cable out of assembly.
8. Remove bolt from pedal support bracket.
9. Open hood and remove pedal assembly mounting nuts from dash panel.
10. Remove assembly.
INSTALLATION
1. Install assembly mounting studs in dash panel.
2. Open hood and install pedal assembly mounting nuts.
3. Install bolt to pedal support bracket.
4. Install ball end of cable in pedal assembly with small screwdriver.
5. Tighten hex screw on cable retaining clamp.
6. Engage cable retainer to pedal bracket.
7. Raise vehicle and install adjusting nut on front cable.
8. Install cable spring and check cable adjustment.
9. Lower vehicle.