RAM 1500 Van V6-3.9L VIN X (1997)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Remove engine cover.
2. Remove air cleaner assembly. Refer to Powertrain Management/Fuel Delivery and Air Induction/Air Cleaner for procedures.
Servo Cable Remove/Install
3. Using finger pressure only, remove speed control cable connector at bellcrank by pushing connector rearward off the bellcrank pin. DO NOT try
to pull connector off perpendicular to the bellcrank.
4. Squeeze tabs on speed control cable and push out of locking plate.
5. Remove servo cable from servo. Refer to Speed Control Servo removal and installation.
6. Reverse removal procedures to install.
