RAM 1500 Van V6-3.9L VIN X (1997)
Park Gear: Service and Repair
REMOVAL
1. Hoist and support vehicle on safety stands.
2. Mark propeller shaft and axle yoke for assembly reference. Then disconnect and remove shaft.
3. Disconnect parking brake cable at equalizer and disconnect exhaust components as necessary.
4. Remove extension housing.
5. Loosen but do not remove bolts that hold governor body to park gear.
6. Rotate transmission output shaft until governor weight assembly is accessible.
7. Remove E-clip at end of governor valve shaft.
8. Remove governor valve and shaft from governor body.
9. Remove snap rings and washer that retain governor body and park gear assembly on output shaft.
10. Remove governor body-park gear assembly from output shaft.
INSTALLATION
1. Install governor body-park gear snap rings and washer on output shaft as follows: