RAM 1500 Van V6-3.9L VIN X (1997)
28. Remove regulator valve line pressure plug, pressure plug sleeve, throttle pressure plug and spring.
Assemble
CAUTION: Do not force valves or plugs into place during reassembly. If the valve body bores, valves and plugs are free of distortion or burrs, the
valve body components should all slide into place easily. In addition, do not overtighten the transfer plate and valve body screws during reassembly.
Overtightening can distort the valve body resulting in valve sticking, cross leakage and unsatisfactory operation. Tighten valve body screws to
recommended torque only.
1. Lubricate valve body bores, valves and plug. with MOPAR ATF+4 transmission fluid.
Valve Body Components
2. Insert rear clutch and rear servo check balls if transfer plate.
3. Install filter screen in separator plate
4. Align and install separator plate on transfer plate. Verify check ball position before installing separator plate on transfer plate.
5. Install new O-ring on converter clutch solenoid and insert solenoid in separator plate. Then secure solenoid in position with attaching screw.
Tighten screw to 4 Nm (35 inch lbs.) torque.
