RAM 1500 Van V8-5.2L CNG VIN T (1999)
Power Door Lock Actuator: Service and Repair
REMOVAL
Front Door
1. Disconnect and isolate the battery negative cable.
Front Door Power Lock Motor Remove/Install
2. Remove the door latch assembly from the front door.
3. Remove the screw that secures the power lock motor to the front door latch.
4. Pivot the side of the power lock motor from which the screw was removed downwards to remove it from the bottom of the front door latch.
5. Reverse the removal procedures to install. Tighten the mounting screw to 2.2 Nm (20 in. lbs.)
Dual Side/Rear Door
On models equipped with dual side or rear doors the power lock motor is integral to the door latch unit. If the power lock motor is faulty or
damaged, the entire door latch unit must be replaced.
Sliding Side or Single Rear Door
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the inside of the door.
