RAM 1500 Van V8-5.2L CNG VIN T (1999)
Housing Assembly HVAC: Specifications
Tighten the heater-A/C housing mounting screws to 2.2 Nm (20 in. lbs.).
Tighten the blower housing mounting screws to 2.7 Nm (24 in. lbs.).
Tighten the two mounting nuts that secure the heater-A/C housing studs on the dash panel above the distribution duct to 4.5 Nm (40 in. lbs.).
Tighten the mounting screws that secure the cover to the rear heater-A/C unit to 2.2 Nm (20 in. lbs.).
Tighten the mounting screws that secure the upper housing to the lower housing of the rear heater-A/C unit to 2.2 Nm (20 in. lbs.).
Tighten the mounting screws that secure the rear heater-A/C unit to the under-body panel with two screws to 1.9 Nm (17 in. lbs.).
Tighten the mounting screw that secure the rear heater-A/C unit ground wire eyelet to the left side panel strainer behind the unit to 1.9 Nm (17 in. lbs.).
Tighten the mounting nuts that secure the rear heater-A/C unit plumbing plate to the underbody panel to 11.2 Nm (100 in. lbs.).
