RAM 1500 Van V8-5.2L VIN Y (1999)
6. Remove the inner door and bin unit from the glove box outer door.
INSTALLATION
1. Position the inner door and bin unit onto the glove box outer door.
2. Install and tighten the eight screws that secure the inner door and bin unit to the glove box outer door. Tighten the screws to 1.9 Nm (17 in. lbs.).
3. Install and tighten the two screws that secure the bottom of the glove box outer door to the bottom of the glove box bin. Tighten the screws to 1.9
Nm (17 in. lbs.).
4. Install the glove box into the instrument panel. Refer to Glove Box Removal and Installation.
5. Install the handle and latch onto the glove box. Refer to Glove Box Components - Handle and Latch Removal and Installation.
6. Reconnect the battery negative cable.
Glove Box Lamp and Switch Removal and Installation
GLOVE BOX LAMP AND SWITCH
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the glove box.
3. Reach through the glove box opening and behind the glove box opening upper reinforcement in the instrument panel to access and depress the
retaining latches on the top and bottom of the glove box lamp and switch housing.
Glove Box Lamp And Switch Remove/Install
4. While holding the retaining tabs depressed, push the glove box lamp and switch unit out through the mounting hole in the mounting tab on the
instrument panel glove box opening upper reinforcement.
5. Pull the glove box lamp and switch out from the mounting hole far enough to access the instrument panel wire harness connector.
6. Disconnect the instrument panel wire harness connector from the glove box lamp and switch connector receptacle.
INSTALLATION
1. Position the glove box lamp and switch to the instrument panel.