RAM 1500 Van V8-5.2L VIN Y (1999)
Fuel Tube and Clamp-Typical
4. Gently cut old fuel tube (line) clamp taking care not to damage plastic fuel tube. Remove and discard old fuel tube clamp.
5. Remove plastic fuel tube from filter/regulator by gently pulling downward. Remove filter/regulator from fuel pump module.
INSTALLATION
1. Install a new clamp over plastic fuel tube.
Tightening Fuel Filter Tube Clamp-Typical
2. Install filter/regulator to fuel tube. Rotate filter/regulator in fuel tube (line) until it is pointed towards drivers side (left side) of vehicle.
3. Tighten line clamp to fuel line using special Hose Clamp Pliers number C-4124 or equivalent. Do not use conventional side cutters to tighten this
type of clamp. Tightening Fuel Filter Tube Clamp-TYPICAL
4. Press filter/regulator (by hand) into rubber grommet.
5. Rotate filter/regulator until pointed towards drivers side (left side) of vehicle.
6. Install fuel tank. Refer to Fuel Tank Removal and Installation.
See: Fuel Tank/Service and Repair
7. Check for fuel leaks.
