RAM 1500 Van V8-5.2L VIN Y (1999)
Throttle Position Sensor Installation-Typical
The throttle shaft end of the throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. If the
sensor will not rotate, install the sensor with the throttle shaft on the other side of the socket tangs. The TPS will be under slight tension when
rotated.
1. Install the TPS and two retaining bolts.
2. Tighten bolts to 7 Nm (60 in. lbs.) torque.
3. Manually operate the throttle control lever by hand to check for any binding of the TPS.
4. Connect TPS electrical connector to TPS.
5. Install air intake tube.
6. Install engine cover.