RAM 1500 Van V8-5.2L VIN Y (1999)
Generator Connectors - Typical Denso
4. Remove B+ terminal mounting nut at rear of generator. Disconnect terminal from generator.
5. Disconnect field wire connector at rear of generator by pushing on connector tab.
6. Remove generator from vehicle.
INSTALLATION
1. Position generator to engine and snap field wire connector into rear of generator.
2. Install B+ terminal to generator mounting stud. Tighten mounting nut to 8.5 Nm (75 in. lbs.) torque.
3. Install generator mounting fasteners and tighten as follows:
-
Generator mounting bolt - 41 Nm (30 ft. lbs.) torque.
-
Generator pivot bolt nut - 41 Nm (30 ft. lbs.) torque.
CAUTION:
-
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
-
When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine to overheat.
4. Install generator drive belt.
5. Install negative battery cable to battery.
