RAM 1500 Van V8-5.9L VIN Z (1998)
Shifter A/T: Service and Repair
REMOVAL
1. Remove the upper and lower column shroud.
2. Disconnect the over drive switch harness (if equipped).
Gear Shift Lever Mounting Screw
3. Remove the gear shift lever mounting screw and remove the lever.
INSTALLATION
1. Install the lever and install the mounting screw and tighten to 20 Nm (177 inch lbs.).
2. Connect the over drive switch harness (if equipped).
NOTE: Route and tie off harness to original location.
3. Install the upper and lower column shroud.