RAM 1500 Van V8-5.9L VIN Z (1998)
2. Insert rear clutch and rear servo check balls in transfer plate.
3. Install filter screen in separator plate.
4. Align and install separator plate on transfer plate. Verify check ball position before installing separator plate on transfer plate.
Installing Converter Cluch Solenoid-32RH
5. Install new O-ring on converter clutch solenoid and insert solenoid in separator plate. Then secure solenoid in position with attaching screw.
Tighten screw to 4 Nm 35 inch lbs.) torque.
Correct Position Of Valve Body Check Balls
6. Position valve body so internal passages and check ball seats are facing upward. Then install check balls in valve body. There are a total of seven
check balls; The one large check ball is approximately 11/32 inch in diameter. The remaining check balls are approximately 1/4 inch in diameter.
7. Align and install assembled transfer and separator plates on valve body. Install and tighten valve body screws alternately in a diagonal pattern to 4
Nm (35 inch lbs.) torque.
