RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Brake Pedal Assy: Service and Repair
REMOVAL
1. Remove the knee blocker under the steering column, to access the pedal.
2. Remove clip securing push rod to pedal.
3. Remove brake pedal shaft nut.
4. Slide brake pedal shaft out and remove the brake pedal.
5. Remove and inspect pedal bushings. Replace bushings if worn or damaged.
INSTALLATION
1. Lubricate pedal shaft and bushings with Mopar multi-mileage grease.
2. Install pedal bushings in pedal, sleeve and support.
3. Position pedal in support and install the pedal shaft.
4. Install the nut on the pedal shaft. Tighten shaft nut to 54 Nm (40 ft. lbs.).
5. Attach push rod to the pedal using a new clip.
6. Check operation of the stop lamp switch.
7. Install the knee blocker.