RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Wheel Speed Sensor: Service and Repair
Rear
REMOVAL - REAR WHEEL SPEED SENSOR
1. Raise and support vehicle.
2. Disconnect wire from rear sensor on axle housing.
3. Remove sensor and bracket mounting bolt and remove sensor and bracket.
INSTALLATION
1. Secure sensor wire to rear brake hose with clips provided.
2. Install sensor and mounting bracket in axle housing. Install mounting bolt and tighten to 24 Nm (18 ft. lbs.).
3. Connect wire to sensor and secure wire to mounting bracket.
4. Remove support and lower vehicle.