RAM 1500 Van V8-5.9L VIN Z LDC (2001)
Wheel Hub: Service and Repair
HUB / BEARING
REMOVAL
NOTE: Bearing and races must be replaced as a set if worn or damaged.
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove disc brake caliper.
4. Remove the dust cap, cotter pin, nut lock, nut and washer from spindle.
5. Carefully slide the hub/rotor from spindle.
CAUTION: Use care to prevent inner wheel bearing and seal from contacting spindle threads during removal).
6. Remove the seal and inner wheel bearing from the hub/rotor.
7. Remove the inner and outer bearing cups from hub/rotor with a pin punch.
INSTALLATION
NOTE: Bearing and races must be replaced as a set if worn or damaged.
1. Install the new bearing cups with an appropriate size driver tool.
2. Apply a coating of MOPAR Wheel Bearing Grease to inner surface area of hub.
3. Clean and grease inner and outer wheel bearings.
4. Install inner wheel bearing and new bearing seal.
5. Inspect bearing and seal contact surfaces on spindle for burrs and roughness.
6. Remove all rough contact surfaces from spindle. Apply a coating of lubricant.