RAM 1500 Van V8-5.9L VIN Z LDC (2001)
17. Remove rear bearing from pinion (Fig. 52) with Puller/Press C-293-PA and Adapters C-293-47.
18. Remove depth shims from the pinion shaft and record shim thickness.
INSTALLATION
NOTE: The ring gear and pinion are serviced in a matched set. Do not replace the pinion without replacing the ring gear. If ring and pinion gears or
bearings are replaced,
1. Apply Mopar Door Ease or stick lubricant to outside surface of bearing cup.
2. Install rear pinion bearing cup (Fig. 53) with Installer C-4308 and Driver Handle C-4171 and verify cup is seated.
3. Apply Mopar Door Ease or stick lubricant to outside surface of bearing cup.